Onn Soundbar Instructions Onn Soundbar Manual 16 Inch 2.0 Onn ONA19SB002 Pairing Setup Power Remote Control Sound Bar User Manual Guide

Onn Soundbar Instructions

Onn TM
Onn 16 2.0-CHANNEL SOUNDBAR
Model: ONA19SB002
PRODUCT GUIDE
Ver.01Rev.02/08/18

Onn Soundbar Manual

Package contents

  • 1. Soundbar 1pc
  • 2. 3.5mm audio to RCA audio cable (Length:1.5m) 1pc
  • 3. Remote control 1pc
  • 4. Product Guide 1pc
  • 5. External adaptor 1pc
  • onn tm
  • Product Guide

Onn Soundbar Speaker Overview

  • 1. Status indicator
  • 2. Wall mount
  • 3. Aux in
  • 4. Optical
  • 5. Power
  • 6. Power on/off
  • 7. Source
  • 8. Volume down
  • 9. Volume up

Status indicator

StandbySolid Red
OpticalSolid Green
Aux inSolid White
Bluetooth pairing modeFlashing blue
Bluetooth device connectedSolid blue
Volume up and downCorresponding to the sound source indicator light flash 1 time
Maximum and minimum volumeCorresponding to the sound source indicator light flash 3 times
MuteSlow flash
TV modeCorresponding to the sound source
indicator light flash 2 times
Music modeCorresponding to the sound source indicator light flash 2 times
Movie modeCorresponding to the sound source
indicator light flash 2 times

Specifications

  • Output Power: 12.5Wx 2(RMS)
  • Frequency Response: 50Hz~20 KHz
  • S/NRatio: ≥65dB
  • Separation: ≥45dB

Remote control

  • 1. Power on off
  • 2. Mute
  • 3. Bluetooth
  • 4. Aux
  • 5. Optical
  • 6. TV mode
  • 7. Music mode
  • 8. Movie mode
  • 9. Volume up
  • 10. Previous track
  • 11. Play /Pause
  • 12. Next track
  • 13. Volume down

Remote control Batteries

Before first use
To prepare the remote control for first use,pull out
the safety strip to activate the battery.
Replacing the battery
When replacing the battery in the remote control,
refer to the diagram below.
1.Pree the catch across.
2.While holding the catch,open the battery door.
3.Fit the battery observing ploarity as shown.
When replacing the battery,use only the same CR2025 type specified.

Power and connection

1.Plug the DC cable from the AC adaptor into the Power jack on the back panel,and plug the AC adaptor into the wall socket.
2.Press to power on/power off.
3.Connect the audio cable to the audio output of any device(such Desktop PC,
Laptop,Smartphone Tablet,MP3,TV etc.)with a 3.5 mm headphone output jack or RCA output jack.
DC in TV Included Not included

Onn Soundbar Pairing

Power and connection

CAN BE USED WITH

Desktop PC
Laptop
Smartphone
MP3
Tablet

Bluetooth Connection
1.Turn on the sound bar and select the Bluetooth mode.
2.Activate the Bluetooth function on your device and search for devices nearby.
3.Find “Onn 16″Soundbar”in the search results and tap to connect.
4.The BluetoothR indicator will turn solid blue on upon a successful connection.
Note:
The Bluetooth indicator will keep flashing when the sound bar is pairing.
Please make sure no other active Bluetooth devices are within range, and that the sound bar is within 3ft/1m away from your device.
Before starting to play via Bluetooth,please lower the volume to a moderate
level.

USER MANUAL INSERTS FOR FCC ID


1.Warning:Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to operate the
equipment.
2.NOTE:This equipment has been tested and found to comply with the limits for a Class B digital device,pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference in a residential installation.This equipment generates,uses and can radiate radio frequency energy and,if not installed and used in accordance with the instructions,may cause harmful
interference to radio communications.
However,there is no guarantee that interference will not occur in a particular
installation.If this equipment does cause harmful interference to radio or television reception,which can be determined by turning the equipment off and on,the user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
3.This device complies with Part 15 of the FCC Rules.Operation is subject to the
following two conditions:
(1)this device may not cause harmful interference,and
(2)this device must accept any interference received,including interference that
may cause undesired operation.
4.RF Exposure Statement
To maintain compliance with FCC’s RF Exposure guidelines,This equipment should be installed and operated with minimum distance between 20cm the radiator your body:Use only the supplied antenna.

How to reset onn soundbar

Onn Soundbar User Manual

Onn Soundbar User Guide

Onn Soundbar Setup

Onn Soundbar troubleshooting

Onn Sound bar Setup

nn Soundbar Setup instructions

Onn Soundbar setup with remote

Onn Soundbar help

Onn Soundbar Bluetooth Pairing to tv

Onn Soundbar Setup with optical cable

Onn Soundbar remote app

Onn Soundbar 16″ 2.0 Manual

Onn 16 Inch Soundbar Manual

Onn 16″ Soundbar Instructions

blast onn 2.0 soundbar instructions

onn soundbar instruction manual

blast onn 2.0 soundbar manual

onn 16 2.0 soundbar manual

onn 16 2.0 soundbar manual

onn 16 inch sound bar manual

onn 16 soundbar manual

onn 2.0 led soundbar manual

onn 2.0 led soundbar with 2 speakers 20 manual

onn 2.0 soundbar manual

onn 20 soundbar manual

onn blast 2.0 soundbar manual

onn bluetooth soundbar manual

onn dolby atmos soundbar manual

onn roku smart soundbar manual

onn roku soundbar manual

onn sound bar instructions

onn sound bar manual

onn soundbar directions